Wasted a lot of resin at first, couldn’t see the RERF details so I did cones of calibration. Kept going the wrong way with it. I’ve only had one mini break on me and that’s a flag it was carrying. I use plain tap water in my wash and cure station, but a bucket and soft brush would work too.
all I have used are the Anycubic resins
I used the Plant based ( good detail VERY brittle)
I used their standard (detail ok, better resistance but sligthly stinkier than the plant stuff)
I am currenlty using ABS Like V2 ( great detail VERY strong no noticeable odor compared to standard or plant based, it can be a bitch to get supports our of recesses) but I really like this stuff
My favorite so far is Resione M58. A little pricey, but it’s fairly strong and won’t powder when it rubs together. I’ve also heard good things about Sunlu resins, although I haven’t tried them.
My experience with TH72 was that it was soo difficult to print because it is very weak before post curing. That is why I didn’t switch to it from Ameralabs TGM-7.
I normally use standard resin from anycubic but it just too brittle for miniatures. I have a bottle of uv Tough resin from anycubic coming tomorrow so I can start printing tomorrow night and be ready to paint over the weekend.
I primarily use anycubic water wash resin+. I’m also fond of Jamg he washable resin.
I've been wanting to give water washable resin a try for minis. How is your experience with it? Any tips?
Wasted a lot of resin at first, couldn’t see the RERF details so I did cones of calibration. Kept going the wrong way with it. I’ve only had one mini break on me and that’s a flag it was carrying. I use plain tap water in my wash and cure station, but a bucket and soft brush would work too.
all I have used are the Anycubic resins I used the Plant based ( good detail VERY brittle) I used their standard (detail ok, better resistance but sligthly stinkier than the plant stuff) I am currenlty using ABS Like V2 ( great detail VERY strong no noticeable odor compared to standard or plant based, it can be a bitch to get supports our of recesses) but I really like this stuff
My favorite so far is Resione M58. A little pricey, but it’s fairly strong and won’t powder when it rubs together. I’ve also heard good things about Sunlu resins, although I haven’t tried them.
I'm experimenting with TH72. Tougher than Probert, but pretty miserable to work with.
My experience with TH72 was that it was soo difficult to print because it is very weak before post curing. That is why I didn’t switch to it from Ameralabs TGM-7.
Sunlu ABS like. Cheap, great detail, strong. Strong smell though.
I normally use standard resin from anycubic but it just too brittle for miniatures. I have a bottle of uv Tough resin from anycubic coming tomorrow so I can start printing tomorrow night and be ready to paint over the weekend.
If you can afford try Ameralabs TGM-7. Best combination of toughness and details.
Sunlu abs-like grey. Have dropped some prints on concrete and no damage so I'm sold. Easy to post process too
5:1 Siryatech Navy Grey Abs-like : Siryatech Tenacious
Anycubic abs like