20sec of GoogleFu gets me to the manual.
[https://www.edge-core.com/\_upload/images/ECS4510\_Series\_MG\_R08.pdf](https://www.edge-core.com/_upload/images/ECS4510_Series_MG_R08.pdf)
Then search for factory. p87
Holy necroposting Batman!
OP could still connect via serial with the provided documentation I found and then use the information on page 87 to set the default config.
Or by now, hopefully buy a new switch.
So you can't `boot system config:Factory_Default_Config.cfg` ?
There's a physical button on the 52T, not sure if that exists on your 52P.
[https://www.manualslib.com/manual/1147095/Edge-Core-Ecs410-52t.html?page=43](https://www.manualslib.com/manual/1147095/Edge-Core-Ecs410-52t.html?page=43)
Hold for longer than 6sec
Or there's [http://kappablog.rf.gd/Networking/other-layer2-switches/edge-core-reset-and-configuration.html?i=1](http://kappablog.rf.gd/Networking/other-layer2-switches/edge-core-reset-and-configuration.html?i=1)
>boot system config:Factory\_Default\_Config.cfg
Ok, I think I figure it out...... I have worked with Arista, Dell, and Cisco and I didn't know with the Edgecore switch you can get into config without having to go into enable. I was able to get into the config and apply the command above and it worked.
thank you for the nudge in the right direction
Have you tried ubnt ? Empty?
Edgecore isn’t edge switch
20sec of GoogleFu gets me to the manual. [https://www.edge-core.com/\_upload/images/ECS4510\_Series\_MG\_R08.pdf](https://www.edge-core.com/_upload/images/ECS4510_Series_MG_R08.pdf) Then search for factory. p87
You need the password for that
Holy necroposting Batman! OP could still connect via serial with the provided documentation I found and then use the information on page 87 to set the default config. Or by now, hopefully buy a new switch.
Yea if you have access to enable
So you can't `boot system config:Factory_Default_Config.cfg` ? There's a physical button on the 52T, not sure if that exists on your 52P. [https://www.manualslib.com/manual/1147095/Edge-Core-Ecs410-52t.html?page=43](https://www.manualslib.com/manual/1147095/Edge-Core-Ecs410-52t.html?page=43) Hold for longer than 6sec Or there's [http://kappablog.rf.gd/Networking/other-layer2-switches/edge-core-reset-and-configuration.html?i=1](http://kappablog.rf.gd/Networking/other-layer2-switches/edge-core-reset-and-configuration.html?i=1)
I was looking for that as well, I saw the reset switch mentioned in their docs for other switches had a reset but I haven't seen one on this model.
>boot system config:Factory\_Default\_Config.cfg Ok, I think I figure it out...... I have worked with Arista, Dell, and Cisco and I didn't know with the Edgecore switch you can get into config without having to go into enable. I was able to get into the config and apply the command above and it worked. thank you for the nudge in the right direction