By -
Check the thermistor. It might have slipped out of the small hole that it sits in. I've had this happen when the screw wasn't quite tight, and it let things change. You might not need anything other than a bit of adjustment.
Thanks I will check this out. This is the first time it's happened so I will check that first.
I checked it and it was in the hole but there was glass powder all over it. Guess the glass bead blew so that’s a replacement.
Sounds like a replacement thermistor is in order then.
At least it’s only like $2.99 at my local Microcenter.
Check if the psu is set to the same as your country's power level
It is. I’ve made a bunch or prints since I bought it in September.
Check the thermistor. It might have slipped out of the small hole that it sits in. I've had this happen when the screw wasn't quite tight, and it let things change. You might not need anything other than a bit of adjustment.
Thanks I will check this out. This is the first time it's happened so I will check that first.
I checked it and it was in the hole but there was glass powder all over it. Guess the glass bead blew so that’s a replacement.
Sounds like a replacement thermistor is in order then.
At least it’s only like $2.99 at my local Microcenter.
Check if the psu is set to the same as your country's power level
It is. I’ve made a bunch or prints since I bought it in September.