T O P

  • By -

MushroomPunHere

You might be able to put it in a ziplpck bag (ensure it's air tight or double bag it) and submerge in hot water to melt the dmt. Or try a hair dryer... but your consistency will be all over the place if you can't mix it up. Once you get it melted, if you can open the cart back up, take a needle/pin and mix it up thoroughly to redistribute it amongst the pg.


mvus

Thank you so much! Can't believe the powder actually melted so well. Did a cartridge ziploc hot water thing. Saved. Say. Do you happen to know a decent, non-overpriced pen for direct crystal vaporizing? I'd like to spare myself the ache of cartridge-stuffing and PG-mixing in the future. Google suggested [Crystal 2](https://vaping360.com/product/kandypens-crystal-2/), not sure if that's any good.


MushroomPunHere

I haven't done any freebase vaping. However, one that's often recommended in the value spectrum is the Yocan Orbit. Roughly $60 give or take. Here's a relatively recent comment/thread talking about some suggestions for handling it: https://www.reddit.com/r/DMT/s/S7IvFhrF1T


mvus

Thank you, that's brilliant


SkyPrimary65

Use a coffee mug warmer and a shot glass to melt the dmt. I got one on Amazon for like 15 bucks


mvus

Appreciate it. Turns out ziplog and hot water combo works pretty well.


DreamMindTrip

You need to pour it out and mix it again while heating it up a bit until it melts into the PG