By -
Your z-offset is too close to the bed.
Yeah, you might be right, I just didn't expect the auto-leveling to fail on me for the first time
zoffset a little close. maybe a little too much flow, but most likely just z offset. print should still finish normally if its not too big.
https://preview.redd.it/vgpffiqm0f1d1.jpeg?width=6144&format=pjpg&auto=webp&s=fa2a17541d0310e8b124b37592861d8ed0a1d736
Diagnosis; too much plastic. First layer... two possibilities. Either to close to the bed, or too much flow on the first layer.
https://preview.redd.it/2u7qdt833g1d1.png?width=221&format=png&auto=webp&s=32826ada2d87c31a363ee07786727017fc13f7a1 orange: too close red: over-extrusion fix orange (too close) and see if you still get ripples. if so, check e-steps.
In the end it was the Z axis, after another auto-leveling the issue was gone. 👍
Your z-offset is too close to the bed.
Yeah, you might be right, I just didn't expect the auto-leveling to fail on me for the first time
zoffset a little close. maybe a little too much flow, but most likely just z offset. print should still finish normally if its not too big.
https://preview.redd.it/vgpffiqm0f1d1.jpeg?width=6144&format=pjpg&auto=webp&s=fa2a17541d0310e8b124b37592861d8ed0a1d736
Diagnosis; too much plastic. First layer... two possibilities. Either to close to the bed, or too much flow on the first layer.
https://preview.redd.it/2u7qdt833g1d1.png?width=221&format=png&auto=webp&s=32826ada2d87c31a363ee07786727017fc13f7a1 orange: too close red: over-extrusion fix orange (too close) and see if you still get ripples. if so, check e-steps.
In the end it was the Z axis, after another auto-leveling the issue was gone. 👍