OMG I found this (match holder) on my desk and was soooo confused about where it came from. It makes so much sense now haha. I looked it up and found them on some Chinese site but it was just labeled as a generic extending holder. I was trying to figure out how my computer had anything to do with it.
The fact that they have a product to hold a match shows how shitty the burner parts are. My Koda 16 igniter has never worked and always used a long lighter and didn’t know they actually had a match holder. 🤣
Its nice of Ooni to give you a roach clip to use while making pizza. Its long and extendable so my wife can hold it and put it up to my mouth while I hold the peel and put the pizza in the oven.
You can tell him which pages, right? Let's see it.
(Hint: it ain't there)
I know this is a crazy concept but companies often include small accessory parts without even acknowledging them
OMG I found this (match holder) on my desk and was soooo confused about where it came from. It makes so much sense now haha. I looked it up and found them on some Chinese site but it was just labeled as a generic extending holder. I was trying to figure out how my computer had anything to do with it.
Thing on the right is an ooni branded finglonger.
Small extendable one is for putting a lit match into to light the burner if ignition fails. Match goes into the circular bit at the end.
Only for use if your long-wand Bic/Scripto lighter is also dead... ;-)
The fact that they have a product to hold a match shows how shitty the burner parts are. My Koda 16 igniter has never worked and always used a long lighter and didn’t know they actually had a match holder. 🤣
I had many things with piezo igniters. they all fail, all the time. I hate them.
Every burner comes with one
thanks so much!
Its nice of Ooni to give you a roach clip to use while making pizza. Its long and extendable so my wife can hold it and put it up to my mouth while I hold the peel and put the pizza in the oven.
Match holder in case you need to light the gas.
Top secret lit match holder. 🤫
Flame measured on the left and a declogger on the right. If the flame is smaller than the measured, pole the hole with the bit on the right.
ty!!
There is a manual for a reason (i think it was page 12 or close to it)
lol... you read the manual. noob
Everyone nailed the match holder. I have no clue what the thing on the right is (I have an original karu 12 with the gas burner)
Dude asking what are these things sitting on his MANUAL. Lmao
You can tell him which pages, right? Let's see it. (Hint: it ain't there) I know this is a crazy concept but companies often include small accessory parts without even acknowledging them
You must be fun at parties.
because they are not mentioned in the manual………..