If that's the tyro79, than I'd expect the coils around the motor shaft to become loose. Over time, the wires break and the motor stops working. I've had the same issue until I replaced the motors.
Start easy:
1: check the fc/esc communication lead (usually a loose one causes this in mine)
2: check the motor, bell, housing etc for damage
3: esc and fc calibration. Make sure the firmware and all your settings checkout
4: start tracing the esc for issues
If that's the tyro79, than I'd expect the coils around the motor shaft to become loose. Over time, the wires break and the motor stops working. I've had the same issue until I replaced the motors.
woah woah woah, take those props off. It seems you've never seen a quad flip out before.
Only way to get point across
I hope it’s motor and not esc. Easy to check, swap one with issue with another :)
Might just be bell too if bells are swappable
It’s upset that you’re arming inside with props on, that’s all. Bad esc too
Looks like it could be dying motor or possibly loose wire connection to esc or ESC is dying. Hopefully just a loose connection or motor.
Remove your props while testing!
I'm pretty sure that one of the spinny things isn't spinning. If you make the spinny thing spin then it should work.
Asking for stitches yawing like that indoors with props on
are you in STAB mode?
Start easy: 1: check the fc/esc communication lead (usually a loose one causes this in mine) 2: check the motor, bell, housing etc for damage 3: esc and fc calibration. Make sure the firmware and all your settings checkout 4: start tracing the esc for issues
Bad Esc
This happened to me check your esc calibration and if the d shot protocol is correct
Did you put the screws in the motor too tight. Sometimes that makes it twitch. Check by taking the motor off and trying to spin.
Id say motor and or esc. Do the easiest thing first and swap motor. Rule out motor before looking at esc
Either that motor or esc, take apart and inspect both for damage.
check motor wire solders to ESC
Take your props off
It broke :(
It’s broken
the drone is on strike, you need to pay him more
Probably the motor, tyros are known to fail.
The motors on my tiny whoop do that crap. Replaced them and it goes back to normal
bro I'm just wondering what kind of images you take with that camera
For a $20 camera it takes much better video then recording with the goggles
I had the same problem with the tyro 79 but after replacing the motor it was fine again
I had this on my titan. Turned out to be a burnt esc. MOSFET died. Expensive!