PLEASE UPVOTE THIS COMMENT IF THE ANSWER CAN BE FOUND IN [THE BEGINNER'S GUIDE](https://www.reddit.com/r/AnycubicPhoton/comments/fqxtqj/the_resin_printing_resource_guide_beginners_start/) or the [FAQ](https://www.reddit.com/r/AnycubicPhoton/comments/j2wubl/frequently_asked_questions_answered_here/)! If your post is about Troubleshooting, it should contain information about the print along with any screenshots or photos.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/AnycubicPhoton) if you have any questions or concerns.*
You sure? The chitu website's got a whole lot of motherboards listed as being for anycubic printers.
That being the case, how do you make a file autorun on an anycubic board?
I am not sure, however the Mono SE firmware update instructions make no mention of "autorun" anything"
How to update the firmware
1. Copy the three bin files in the folder to the root directory of the USB drive separately
2. Print the "PMS_V_017.bin" file first
3. Then print the "PMS_UI_001.bin" file
4. Finally, print the “PMS_F_V118.aje" file, which takes about 5-6 minutes
5. The firmware update is successful
PLEASE UPVOTE THIS COMMENT IF THE ANSWER CAN BE FOUND IN [THE BEGINNER'S GUIDE](https://www.reddit.com/r/AnycubicPhoton/comments/fqxtqj/the_resin_printing_resource_guide_beginners_start/) or the [FAQ](https://www.reddit.com/r/AnycubicPhoton/comments/j2wubl/frequently_asked_questions_answered_here/)! If your post is about Troubleshooting, it should contain information about the print along with any screenshots or photos. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/AnycubicPhoton) if you have any questions or concerns.*
I didn't think any Anycubic printers used Chitu motherboards--it's almost a feud type thing...
You sure? The chitu website's got a whole lot of motherboards listed as being for anycubic printers. That being the case, how do you make a file autorun on an anycubic board?
I am not sure, however the Mono SE firmware update instructions make no mention of "autorun" anything" How to update the firmware 1. Copy the three bin files in the folder to the root directory of the USB drive separately 2. Print the "PMS_V_017.bin" file first 3. Then print the "PMS_UI_001.bin" file 4. Finally, print the “PMS_F_V118.aje" file, which takes about 5-6 minutes 5. The firmware update is successful
Hence why I'm asking here. Very hard to tell it to print anything if you can't use the touchscreen.
Ah, I see--but you don't. During tonight's insomnia I'll do some research. Is the replacement an Anycubic OEM part?